About the Lock Block Tab
KVAL Operation Manual
3-27
About the Lock Block Tab
The Lock Block Screen is located under the
Config Tab
. Select the
Lock
Block Tab.
At this screen, set controls for the
Cutter Head
to compensate for a door with a
lock block. The
lock block section of the door is defined and the
Cutter Head
speed will slow down to cut through
the harder wood.
To create a lock block region:
1.
Get the lock block location of the door from the blueprint or by measuring the door.
2.
Enter the desired speed percentage. The cutter head will slow down to this percent-
age when is reaches the lock block location.
3.
Enter location of the lock block.
a.Wood/FG Speed Percent:
Modifies the feed rate to cut
wood or fiberglass skin
doors.
b.
Steel Speed Percent:
Modifies the feed rate to cut steel skin doors.
c.
Bottom of Door to Block:
The location of the block with the bottom of the
door as a reference.
d.
Extent Along Length:
The length of the lock block.
e.
Extent Along Width:
The depth of the block in reference to the width of the
door.
f.
Also on Hinge Side:
Use if the block is mirrored on the hinge side of the door.
4.
Select the
Save
button to store the Lock Block Parameters
Bottom Of Door To Block (36 '')
Width (8 '')
Length (15 '')
Lock Side
Hinge Side
.
Summary of Contents for DL-NCD
