Installing the Camera and In-Car Microphone (ICM)
Manual Part Number:
006-1219-00 Rev. 0
3–7
Digital Eyewitness
®
HD
In-Car Video System
f. Hold the mounting tab in this position for one (1) minute before releasing it. After
one (1) minute, the technician may use painter’s tape to hold the mounting tab in
position while the adhesive continues to set up.
IMPORTANT
The technician needs to make sure to remove all tape adhesive
residue from the windshield after removing the tape.
g. Allow the adhesive to cure for two (2) hours.
IMPORTANT
The adhesive MUST be allowed to cure for a minimum of two (2)
hours before installing the camera on the mounting tab. Failure
to do so will compromise the bonding strength of the adhesive
and will likely result in a failure.
IMPORTANT
If the mounting tab needs to be removed after the adhesive has
cured, use Loctite
®
Corporation’s Chisel Gasket Remover 790.
Distributors of this product may be located by calling
1-800-323-5206.
4.
This step applies when using the J-B Weld® ClearWeld™.
a. Remove the replaceable cap.
b. Press down on plunger and squeeze equal amounts onto a disposable surface.
c. Mix the epoxy thoroughly.
d. Apply an even coat of the epoxy to the back of the mounting tab with appropriate
tool.
IMPORTANT
The adhesive MUST be allowed to cure for a minimum of one (1)
hour before installing the camera on the mounting tab. Failure to
do so will compromise the bonding strength of the adhesive and
will likely result in a failure.
If the temperature is below 40ºF, the epoxy will require more
time to set.
5. Locate the camera pivot assembly and the jam nuts for the pivot assembly mounting
studs.
6. Install the two (2) jam nuts on the pivot assembly mounting studs. One nut goes on each
stud. Thread the nuts all the way down the length of the threads.
Figure 3-10.
Jam Nuts Properly Installed
