Installing the Tablet Monitor Controller (TMC)
Digital Eyewitness
®
HD
In-Car Video System
2–8
Manual Part Number:
006-1219-00 Rev. 0
10.
Place one ¼” x ½” hex cap screw with two ¼” x 1-1/4” fender washers through the hole
punched for the center nut. Place one fender washer on the outside of the headliner.
Figure 2-12.
Preparing the Fastener for the Center Nut
11.
Attach the center nut with TMC to the ¼” x ½” hex cap screw. Do not fully tighten at this
time. This is done to allow the necessary movement for attaching the top two screws.
12.
Attach top two 8/32” x 5/8” screws into top two holes. Do not fully tighten either side until
both screws have been started. Once both are started, proceed to tighten snug. Do not
over tighten.
13.
Tighten ¼” x 1/2” hex cap screw snug. Do not overtighten as it could penetrate the
TMC.
14.
Place excess cable above headliner and reattach overhead.
15.
Attach visor clip. When reattaching clip, ensure that the TMC cable is routed in front of
the clip towards the windshield and it is not pinched.
Figure 2-13.
Final Mounting Position
