Installing the Tablet Monitor Controller (TMC)
Manual Part Number:
006-1219-00 Rev. 0
2–7
Digital Eyewitness
®
HD
In-Car Video System
5.
Position the mounting plate for the TMC and place the center nut 3” above the center
cut that was made in the headliner in the previous step. Once properly position, poke a
1/4” hole for the center nut and the top two (2) holes on bracket.
IMPORTANT
Make sure that once the position for the TMC has been selected
the installer must be sure that the TMC’s position will not block
the user’s view of the rearview mirror.
Figure 2-10.
Creating the Hole for the Center Nut
6.
Run the TMC cable above headliner from passenger side, on the front side of the visor
clip and through the bracket. Leave 18” of cable length.
Figure 2-11.
Wire Routing Through Headliner
7.
Attach the cable to the tablet and run the cable through the channel.
8.
Align the TMC with the mounting plate and install the bottom two (2) screws to secure
the mounting plate to the tablet. Ensure that the top two (2) holes are centered.
9.
Acquire two (2) 8/32” x 5/8” machine screws and place one (1) 1/8” x ¾” fender washer
on each screw. Reach through the hole where the overhead console will be installed
and insert each machine screw through the holes that were punched through the
headliner for the two upper corners of the mounting plate and hand start each screw.
TMC cable
Overhead
console cable
