Installing the Camera and In-Car Microphone (ICM)
Manual Part Number:
006-1219-00 Rev. 0
3–3
Digital Eyewitness
®
HD
In-Car Video System
6. Pivot the sun visor out of the way.
7. Remove the factory screw(s) that are used to secure the sun visor clip to the headliner.
8. Remove the sun visor clip.
9. Position the bracket in its mounting position.
10. Position the sun visor clip over the mounting bracket. Line up the clip with the large,
square hole in the bracket.
11. Install the new, longer mounting screws from the mounting kit to secure the clip and the
mounting bracket to the headliner.
CAUTION
The kit comes with two (2) sets of
screws of different lengths. When
possible use the shorter pair of screws.
If the longer screws are used, they may
penetrate the outer roof panel.
Figure 3-5.
Installing the Sun Visor Clip over the Mounting Bracket
12. Make sure that the spot on the windshield for mounting the audio antenna is clean and
dry.
13. Remove the plastic film that covers the adhesive strip on the back side of the antenna.
14. Position the antenna at the top of the windshield, with the cord routed back up under the
headliner. The recommended location is on the passenger side of the vehicle in the
upper corner of the windshield.
Note: Any excess cable for the remote antenna should be dog-boned and stowed above
the headliner. Refer to Managing Excess Cable in Chapter 4, Cable Installation,
for information on how to dog-bone the cable.
