Installing the Camera and In-Car Microphone (ICM)
Digital Eyewitness
®
HD
In-Car Video System
3–6
Manual Part Number:
006-1219-00 Rev. 0
Figure 3-8.
Windshield Mounting Tab
Figure 3-9.
Proper Orientation of the Windshield Mounting Tab
2. Use a clean, lint-free cloth that is saturated with rubbing alcohol to clean the mounting
location on the inside of the windshield and the mounting surface of the mounting tab.
3. This step applies when using the Rearview mirror adhesive kit.
a. Locate the activator solution for the adhesive. Squeeze the activator vial until it
breaks. Once the vial breaks, remove the sleeve.
b. Apply a generous amount of activator to the area of the windshield where the
mounting tab will be mounted. Set the mounting tab aside.
IMPORTANT
The activator MUST be allowed to dry for a minimum of five (5)
minutes. Failure to do so will compromise the bonding strength
of the adhesive and will likely result in a failure. If the bond fails,
the camera will fall and may be damaged as a result.
c. Locate the tube of adhesive and remove the cap. It may be necessary to cut or
snap the cap off.
d. Apply one (1) or two (2) drops of adhesive to the side of the mounting tab that will
be touching the windshield.
e. Carefully position the mounting tab on the windshield, making sure that it is
properly positioned. The side with the adhesive should be placed against the
windshield where the activator was placed earlier in this procedure.
