OC60-E2, OC95-E2, WSM
ENGINE
S-30
Side Bearing
(When removing)
A
Lift up the side bearing by the flat screw driver as shown in
figure.
(When reassembling)
A
Make sure the oil groove (1) in the side bearing comes toward
the crank gear.
A
Make sure the anti-fall spring pin (2) for the side bearing is not
stretching out of the bearing surface.
A
Keep the spring pin head A above the surface (not greater
than the side bearing thickness as table below).
A
Do not confuse the above side bearing with that at the
crankcase.
Oil Seal
(When reassembling)
A
Place the side cover on the crankcase and drive in the oil seal
(3) with a special tool. (Apply oil to the inner and outer
surfaces of the oil seal beforehand.)
A
The oil seal mounting hole is used for the socket and spigot
joint. Keep this hole 7 mm below the side cover as illustrated.
A
Use a special tool, because otherwise the oil hole may be
covered.
Spring pin head A
OC60-E2
1.5 to 1.7 mm
0.059 to 0.067 in.
OC95-E2
1.7 to 2.2 mm
0.067 to 0.087 in.
(1)
Oil Groove
(2)
Spring Pin
0000009233E
(1)
Crankshaft
[A]
Direct Coupling
(2)
Camshaft
[B]
1/2 Camshaft Reduction
(3)
Oil Seal
0000009234E
