OC60-E2, OC95-E2, WSM
ENGINE
S-29
Governor Gear and Oil Pump
1. Remove the stopper (1).
2. Pull out the gear (2).
3. Remove the spring pin (3).
A
The circumference of the spring pin hole swells out when the
pin has been taken out. Correct this area flat.
4. Remove the three screws retaining the oil pump cover.
5. Push out the inner rotor shaft (5) and outer rotor (4).
(When reassembling)
A
Make sure the slit of the spring pin (3) faces the oil pump.
A
Make sure the spring pin stretches at equal distance left and
right out of the shaft.
A
Place the stopper so that its knob (7) be fitted in between the
two projection (8) of the gear. See the figure.
A
Apply oil each section.
A
Finally pull the gear to see if it is tight in position.
Clearance between
gear case and
governor gear A
OC60-E2
1.5 mm
0.059 in.
OC95-E2
4.5 mm
0.177 in.
(1)
Stopper
(5)
Inner Rotor
(2)
Governor Gear
(6)
Cover
(3)
Spring Pin
(7)
Knob
(4)
Outer Rotor
(8)
Projection
0000009232E
