ASSEMBLY INSTRUCTIONS
92
INSTALLING THE LOADER
To avoid personal injury or death:
A
When starting the engine and operating the
hydraulic-control-valve, always sit in the
operator's seat.
1. Slowly drive the tractor between the side frames of the
loader until the rear portion of both side frames
touches the main frames as shown in the following
figure.
2. Stop the engine.
3. Connect the 4 hoses with couplers to the fittings on the
control valve as indicated with color marks.
4. Then connect the protective caps and plugs to each
other.
5. Start the engine and run at idle.
6. Slowly move the hydraulic-control-lever to the dump
position to lower the side frames into the main frames,
and engage the bosses of the side frames to the guide
plates of the main frames.
7. Then lift the weight off the front wheels with the loader.
Do not lift the wheels off the ground.
A
Do not lift the front wheels with the stands.
8. Stop the engine.
9. Reinstall the mounting pins and secure them by
inserting the retaining bars of the pins into the holes of
the stays on the side frames.
10. Start the engine.
11. Raise the boom until the stands can be rotated.
12. Stop the engine.
13. Store the stands to their original positions and secure
them with the spring pins as shown.
(1) Side frame
(2) Main frame
(1) Hoses
(1) Hydraulic control lever
(1) Mounting pin
(2) Retaining bar
(A) Insert
