23
ASSEMBLY INSTRUCTIONS
2. Connect the hoses between the connector assembly
stay and the valve as shown in the figure.
A
Make sure valve color mark, connector assembly cap
color and hose color band are matching.
A
With all the hoses connected to the valve, be certain
that any of the hoses is out of close contact with the
other hoses, the fittings and edges.
A
If the above problem is found, correct the hoses to
remove their twist by loosing the nut shown in the
figure and readjusting the fitting angle for avoiding
such close contact.
A
To prevent hose twisting both of hose ends are
connecting to adapter first then tighten.
3. Attach the label on the back of the side frame (RH).
A
Wipe off the dust, oil and grease completely from label
cover surface.
A
Do not use the cotton work gloves at the time of label
attachment.
And also be careful not to touch the label adhesive
with your hand.
A
The bubble must not remain after sticking.
C
Controller stand section
1. Remove the cover of the tractor.
(1) Hydraulic hose (Red, 465 mm (18.3 in.),
3/4-UNF and 3/4-UNF)
(2) Hydraulic hose (Blue, 394 mm (15.5 in.),
3/4-UNF and 3/4-UNF)
(3) Hydraulic hose (Yellow, 500 mm (19.7 in.),
3/4-UNF and 3/4-UNF)
(4) Hydraulic hose (White, 447 mm (17.6 in.),
3/4-UNF and 3/4-UNF)
(A) 90 side
(1) Fitting
(2) Nut
(1) Label of warning 8
