Operation
63
Checking the oil level of the hydraulic system
Check the oil level in the sight glass (1). The oil level should be half
way up the sight glass. Carefully check the position of the hydraulic
cylinders before topping up the oil. For more information see the
"Topping up/changing the hydraulic oil" section (page 133).
Greasing the bucket bolts and bucket linkage bolts
!
Start engine (page 68).
!
Position arm and bucket as shown in the figure.
!
Stop the engine (page 70).
!
Lubricate all greasing points (see figure to the right) – see the
"Recommended lubricants" section (page 146) – by injecting
grease until fresh grease emerges.
Operate the boom, arm, bucket and boom swing
mechanism so that all hydraulic cylinders are extended
half way. Lower the dozer onto the ground. Set extend-
able track width (KX016-4/KX018-4/KX019-4) to
standard track width.
See the "Placing out of operation" section (page 93).
Wipe emerged grease off immediately and store dirty
cleaning cloths in the containers provided for disposal.
