ASSEMBLY
OM 0336QH-A
14
Installing the PTO Drive Kit B2793 (Optional
)
(Figure 4b)
1.
Install a 1/4" NF grease fitting (item 1) on each
1" flange bearing (item 2). Place the flange
bearing on each subframe cross plate (item 9)
as shown making sure to point the bearing's
grease fitting upward as illustrated.
2.
Using a punch, make a mark on the output
shaft (item 3) at 9 3/8" from the end of the
shaft with the longest splines and slide it inside
each flange bearing making sure to direct the
longest splined end towards the rear of the
subframe.
3.
Secure each flange bearing with the
5/8"NC
x 1 3/4" lg hex bolts (item 4),
5/8"
lockwashers (item 5) and
5/8"NC nylon insert
locknuts (item 6) as illustrated on figure.
Tighten at 165 lbs-pi or 224 N-M.
4.
Position the output shaft so that the mark is
behind the rear cross plate as shown on figure.
Apply threadlocker on the bearing setscrews
and tighten securely. Then, grease each
flange bearing.
5.
After the subframe is mounted on the tractor
(see following pages for the procedure) attach
the longest yoke of the fixed driveline (item 7A)
to the output shaft (item 3). Attach the
driveline's quick connect yoke (item 7B) to the
tractor's mid PTO.
IMPORTANT: In order to avoid damaging the
fixed driveline (item 7) remove it when using
the blade.
6.
The driveline's male half (item 8) must be
installed when mounting the snowblower or the
rotary broom but it's not required when using the
blade.
WARNING:
To avoid serious
personal injury: Make sure that the quick
coupler is securely locked in place. A "click"
must be heard.
WARNING
: The driveline can be
damaged and could cause serious personal
injury if the quick hitch is not attached
properly.
IMPORTANT: In order to avoid damaging the
driveline kit components, do not raise or
lower the snowblower when blowing snow.
This should only be done when the
snowblower is idle.
Figure 4b
B2793
F
OR
T
RACTORS
B3030 WITH
C
AB
1
2
4
5
6
8
7A
7B
7
3
2
4
5
1
MARK
OUTPUT SHAFT
9 3/8"
ALIGN
