ASSEMBLY
OM 0336QH-A
13
5 1/8"
Figure 4a
B2792
F
OR
T
RACTORS
B3030 WITHOUT
C
AB
B2630 - B2710 - B2910, B3200
AND
B7800
7B
7A
2
4
4
4
6
6
5
1
9
2
5
3
1
7
8
Installing the PTO Drive Kit B2792 (Optional
)
(Figure 4a)
1.
Install a 1/4" NF grease fitting (item 1) on each
1" flange bearing (item 2). Place the flange
bearing on each subframe cross plate (item 9)
as shown making sure to point the bearing's
grease fitting upward as illustrated.
2.
Slide the 1" output shaft (item 3) inside each
flange bearing making sure to direct the longest
splined end towards the rear of the subframe
and to install the bearings in the correct
position.
3.
Secure each flange bearing with the
5/8"NC x 1 3/4" lg hex bolts (item 4),
5/8"
lockwashers (item 5) and
5/8"NC nylon
insert locknuts (item 6) as illustrated on
figure 4. Tighten at 165 lbs-pi or 224 N-M.
4.
Position the output shaft so that it exceeds
the rear cross plate by 5 1/8". Apply
threadlocker on the bearing setscrews and
tighten securely. Then grease each flange
bearing.
5.
After the subframe is mounted on the tractor
(see following pages for the procedure)
attach the longest yoke of the fixed driveline
(item 7A) to the output shaft (item 3). Attach
the driveline's quick connect yoke (item 7B)
to the tractor's mid PTO.
IMPORTANT: In order to avoid damaging
the fixed driveline (item 7) remove it when
using the blade.
6.
The driveline's male half (item 8) must be
installed when mounting the snowblower or the
rotary broom but it's not required when using
the blade.
WARNING:
To avoid serious
personal injury: Make sure that the quick
coupler is securely locked in place. A
"click" must be heard.
WARNING
: The driveline can be
damaged and could cause serious
personal injury if the quick hitch is not
attached properly.
IMPORTANT: In order to avoid damaging
the driveline kit components, do not raise
or lower the snowblower when blowing
snow. This should only be done when the
snowblower is idle.
