ASSEMBLY
OM 0336QH-A
16
1
3
5
4
6
7
8
2
9
9
10
9
11
POSITIONNER LES
TUBES VERS L'AVANT
10
WITHOUT LOADER
T
RACTORS
B3030
WITH
OR
WITHOUT
C
AB
- B2630
Figures 5.2
POSITION THE TUBES
TOWARD THE FRONT
Tractor WITHOUT Front Loader Brackets
Tractors B3030 with or without Cab - B2630
(fig.5.2)
Preparation:
Before installing the subframe,
remove the lawnmower and front loader from the
tractor by following the instructions in the
operator's manual of the tractor.
IMPORTANT:
The subframe and front loader
must never be installed on the tractor at the
same time.
WARNING:
To avoid serious personal
injury: Park the tractor on level ground, place
the transmission in neutral, set the parking
brake, disengage the PTO, place all control
levers in neutral, shut off the engine, remove
the ignition key and allow the rotating parts to
stop BEFORE attaching the subframe
underneath the tractor.
1.
Attach,
without tightening
, the left rear
bracket (item 1) and the spacer 3/8" (item 2)
to the tractor frame (item 3) using the two
M16 x 1.50mm x 50mm lg hex. bolts (item 4)
and 16mm lockwashers (item 5).
2.
Attach,
without tightening
, the right rear
bracket (item 11) and the spacer 3/8" (item 2)
to the tractor frame (item 3) using the two
M16 x 1.50mm x 50mm lg hex. bolts (item 4)
and 16mm lockwashers (item 5)
.
3.
Making sure to use the correct hole
configuration and tube position,
a
ttach,
without tightening
, the rear support (item
10) to the left and right rear brackets, using
the ø5/8"NC x 2" lg hex bolts (item 6),
ø11/16"flat washers (item
9), ø5/8"
lockwashers (item 8) and ø5/8"NC nylon
insert locknuts (item 7) as illustrated.
4. Continued page 19 #5.
