12
SERVICE WORK ON THE CHASSIS
52
Warning
Danger of poisoning
Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
M00511-11
Main work
–
Check the throttle cable routing. (
–
Make sure that no cables are trapped or damaged.
–
Plug in the connector
for the fuel pump.
B01077-11
–
Position the fuel tank.
–
Position the intake flange on the throttle valve body.
–
Tighten hose clamp
.
M00510-11
–
Plug in connector
.
–
Position engine breather hose
.
M00509-11
–
Mount and tighten screws
on both sides.
Guideline
Screw, fuel tank
M8
15 Nm
(11.1 lbf ft)
Loctite
®
243™
–
Mount and tighten screw
.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
–
Mount the fuel tank breather.
M00512-10
–
Thoroughly clean the plug-in connection of the fuel line using compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line clogs the injection valve.
–
Remove the wash cap set. Lubricate the O-ring and connect the plug-in connec-
tion
for the fuel line.
Info
Route the cable and fuel line at a safe distance from the exhaust system.
Finishing work
–
Lock the seat. (
