18
SERVICE WORK ON THE ENGINE
90
B01129-10
–
Pull oil filter
out of the oil filter housing.
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
B01127-10
–
Position oil screen
with the O-rings on a pin wrench.
–
Position the pin wrench through the drilled hole of the screw plug in the opposite
section of the engine case.
–
Push the oil screen all the way into the engine case.
B01131-10
–
Mount and tighten screw plug
with the O-ring.
Guideline
Screw plug, oil screen
M20x1.5
15 Nm
(11.1 lbf ft)
–
Mount and tighten the oil drain plug
with the magnet and a new seal ring.
Guideline
Oil drain plug with magnet
M12x1.5
20 Nm
(14.8 lbf ft)
B01130-10
–
Lay the motorcycle on its side and fill the oil filter housing to about
⅓
full with
engine oil.
–
Insert the oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
.
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
M6
10 Nm (7.4 lbf ft)
–
Stand the motorcycle upright.
M00534-10
–
Remove the oil filler plug
with the O-ring from the clutch cover and fill up with
engine oil.
Engine oil
1.0 l (1.1 qt.)
Engine oil (SAE 10W/50) (
Alternative engine
oil
Engine oil
(SAE 10W/60)
(00062010035)
Info
Too little engine oil or poor-quality engine oil results in premature wear to
the engine.
–
Install and tighten the oil filler plug with the O-ring.
Danger
Danger of poisoning
Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
