KTM 690 LC4 2007, Repair Manual

Page: 60 / 95

6-3
– Grease and mount a new O-ring
1
.
– Slide special tool 750.29.080.000
2
onto the generator end of the
crankshaft.
– Slide special tool 585.29.005.000
3
on the balancer shaft.
– Insert the crankshaft in the bearing seat and remove
750.29.080.000.
– Liberally lubricate the shaft seal ring for the water pump.
– Insert the balancer shaft
4
in the bearing seat, making sure the
A
and
B
marks are aligned.
– Remove 585.29.005.000 from the balancer shaft.
– Mount the stop disks for the balancer shaft
5
and main shaft
6
,
slide the inner bearing ring for the countershaft
7
and special tool
750.29.080.050
8
onto the crankshaft.
– Degrease the sealing area and apply a thin layer of Loctite 5910
(584.29.059.200).
– Mount the left case half, tapping lightly with a plastic hammer if
necessary.
! CAUTION !
D
O NOT PULL THE CASE HALVES TOGETHER WITH THE SCREWS SINCE THIS WILL
DAMAGE THE BEARINGS AND CASE
.
– Remove 750.29.080.050.
1
2
3
4
A
B
5
6
7
8