KTM 690 LC4 2007, Repair Manual

Page: 72 / 95

6-15
Left side of the engine
– Lay the engine on its side, fill the oil filter housing half full with
engine oil and mount a new oil filter
1
.
– Mount the oil filter cover
2
with a new O-ring, mount the screws
(M5x16) and tighten to 6 Nm.
NOTE: both oil filter covers are identical.
– Move the engine back into a vertical position.
– Mount new O-rings on the oil screen
3
and plug.
– Slide the oil screen on a pin wrench. Insert the pin wrench through
the opening in the bore on the opposite engine case wall and slide
the oil screen all the way into the engine case. Pull out the pin
wrench, screw in the plug (A/F 13 mm) and tighten to 15 Nm.
! CAUTION !
A
N INCORRECTLY MOUNTED OIL SCREEN LOSES ITS FILTERING EFFECT AND LEADS
TO EXCESSIVE ENGINE WEAR
.
NOTE: both oil screens and plugs are identical.
– Insert both contact springs
4
in the bores.
– Mount both contact bolts
5
and a new O-ring
6
.
– Mount the gear sensor
7
, apply Loctite 243 to the screws (AH
M5x12) and tighten to 5 Nm.
– Mount the centering sleeves, mount a new gasket and mount the
generator cover. Tighten the screws (see photo for lengths) to 10
Nm, applying Loctite 243 to the screw
8
.
2
1
6
4
5
5
7
M6x30
M6x25
M6x25
M6x30
M6x25
8
3