- 27 -
7.6.1.9 Cell lock cycle s.
Menu / Accessories / Transport auger / Cell lock cycle s. (0 sek.)
If some straw anyway are blocking the fuel sensor, we can force the cell lock to rotate each 20 sek., to
remove the straw.
The running time for the cell lock in this cycle, is the time set in parameter 7.6.1.7
7.6.1.10 Fuel consumption
We have the opportunity to register the consumption of the fuel used in the boiler.
Although, it is not suitable for wood chips because the variation is to large relative to how much fuel the
transport screw will bring forward.
To make the controller calculate the consumption of fuel, 3 values are needed, as written in the next 3
chapter.
For further description this function please go to chapter 9.
7.6.1.10.1 Fuel kg.
Menu / Accessories / Transport auger / Fuel kg. (1)
Measured quantity can be written with values from 1-255
7.6.1.10.2 Fuel div.
Menu / Accessories / Transport auger / Fuel div. (10)
Weight decimals 1 = 1-255 kg, 10 = 0,1-25,5 kg and 100 = 0,01-2,55 kg
7.6.1.10.3 Fuel s.
Menu / Accessories / Transport auger / Fuel s. (0 sek.)
The time that the auger has been running during the measuring.
7.6.1.10.4 Reset fuel counter
Menu / Accessories / Transport auger / Reset fuel counter (yes)
When you get a new load off fuel you can reset the counter in the menu.
7.6.2 Ash auger.
Menu / Accessories / Ash auger
To run the boiler with the automatic ash auger, there are two parameters to notice.
7.6.2.1 Ash auger on s.
Menu / Accessories / Asch auger / Ash auger on s. (10 sek.)
When the Ash auger is activated the auger shall not run less than five seconds to ensure an effective
transport of the ash.
7.6.2.2 On when fuel sum m.
Menu / Accessories / Asch auger / On when fuel sum m. (10 min)
How often the ash screw has to run is chosen from the type of fuel and how much fuel has been
transported into the boiler.
The Ash auger will be started, when the sum of the stoker’s feeding time is reached.