7 Operation
43 of 104
mini-Compacta
2317.886/16-EN
Table 22:
Measured value parameters
Parameter
Description
1.1.1
Level (Analog)
Displays the fill level (analog measurement) [mm]
1.1.3
Mains Voltage
Displays the mains voltage [V]
1.2.1
Operating Hours Pump 1
Displays the operating hours of pump set 1 [h]
1.2.2
Start Count Pump 1
Displays the number of starts of pump set 1
1.3.1
Operating Hours Pump 2
Displays the operating hours of pump set 2 [h]
1.3.2
Start Count Pump 2
Displays the number of starts of pump set 2
2.1.1
Pending Messages
Displays the pending messages (only for errors / faults)
7.3.2 Displaying and changing parameters
The parameters that you can call up depend on the operating mode and
measurement method. Only relevant parameters are displayed.
Table 23:
Displaying and adjusting parameters and parameter values
Esc
OK
Step 1: Activating the setting mode
1. Press and hold the ESC key and press the OK key.
ð
P 3.3.2 is displayed.
Step 2: Navigating
1. Use the arrow keys to select the required parameter.
OK
Step 3: Confirming the parameter
1. Press the OK key to confirm the selected parameter.
ð
The selected parameter value is displayed immediately.
Esc
OK
Step 4: Changing the parameter value
ü
For multi-digit parameter values, the position to be entered
flashes.
1. Press the OK key or ESC key to select the position of the
parameter value.
ð
The position to be entered moves one digit to the right or
left respectively.
2. Use the arrow keys to change the numerical value.
OK
Step 5 a: Confirming the parameter value
ü
The required position has been adjusted as required.
1. Press OK to confirm the adjusted parameter value.
ð
The parameter value is saved.
ð
The display shows the selected parameter.
