KSB Amacan S 1000-600, Installation & Operating Manual

Page: 24 / 126

5 Installation at Site
24 of 126
Amacan S
1589.837/01-EN
230
101
Fig. 6: Visual inspection for signs of oil leakage
For topping up the lubricant reservoir the pump set needs to be partly dismantled
and reassembled.
Observe all safety instructions when carrying out the following steps of dismantling/
reassembly:
Table 7: Dismantling/reassembly steps
Sequence Steps See the following section
1 Placing the pump in a vertical
position ( ð Section 3.2.2, Page 12)
2 Removing the bellmouth ( ð Section 7.5.3, Page 64)
3 Removing the impeller ( ð Section 7.5.4, Page 64)
4 Filling in the lubricant
(
ð Section 7.4.1.4.2, Page 61)
5 Fitting the impeller ( ð Section 7.6.5, Page 75)
6 Fitting the bellmouth ( ð Section 7.6.6, Page 76)
7 Adjusting the clearance ( ð Section 7.6.7, Page 77)
5.2.4 Checking the direction of rotation
WARNING
Hands and/or foreign objects in the pump casing
Risk of injuries, damage to the pump!
▷
Never insert your hands or any other objects into the pump.
▷ Check that the inside of the pump is free from any foreign objects.
▷ Verify that the transport lock has been removed.
▷ Take suitable precautions (e.g. wear safety goggles).
WARNING
Improper handling when placing the pump set in a vertical/horizontal position
Personal injury and damage to property!
▷
Use one or two pieces of lifting equipment, depending on the pump (set) size.
▷ Use appropriate means to secure the pump set against tilting, tipping over or
rolling off.
▷
Maintain a safe distance during lifting operations (load may swing when being
lifted).
▷
Use additional supports for the transport holder to secure it against tilting.
WARNING
Improper positioning of pump set when checking the direction of rotation
Personal injury and damage to property!
▷ Use appropriate means to secure the pump set against tilting or tipping over.