R E P A I R
Removing injector plate, deblocking of injector
Solid residues in the water circuit can block the injector completely. An example is the
development of calcium particles if the machine is not descaled periodically. Therefore
this error appears during descaling frequently.
4. Close locking handle.
5. Release latch by pressing a suitable pin (dia. 1.8 mm max. e.g. a paper clip)
through hole and remove injector plate by pulling it down.
1. Remove water tank.
2. Remove cup holder.
3. Take cleaning needle out of support
in housing back.
Danger of injury -
sharp pointed
injector!
The extraction head
is adjusted to a spe-
cific injector plate.
Therefore do not
exchange the injector
plate or mix up different
injector plates.
