10
Settings
10.4
Adjusting the twine limiter
80
Bellima F 130
Original Operating Instructions 150000148_06_en
10.4
Adjusting the twine limiter
For the "Twine tying" or "Net and twine tying" version
RPG000-033
The position of the twine limiters (1) determines the distance of the outermost wrapping of the
twine to the outer edge of the bale. The twine limiters (1) must be set independently of the
length and type of crops to prevent the twine from slipping off the round bale.
Length of crop material
Distance of the two twine limiters to each
other
short
close
medium
medium
long
wide
Make the following settings equally on the right-hand and left-hand side:
Loosen the screws (2).
Shift twine limiter (1) in direction of the arrow to the desired position. Make sure that the
twine limiter (1) on the right-hand and left-hand side is set equally.
Tighten the screws (2).
10.5
Setting the number of net layers
For the "Net wrapping" or "Net and twine tying" version
RPG000-022
The number of net layers is set via the setting screw (1) on the right-hand side of the machine.
Proceed as follows to set the number of net layers via dimension X:
