Krick ro1160, Assembly And Operating Instructions Manual

Page: 31 / 72

- Glue the rudder bushes 4.4 to the hull and the
installation cradle using UHU acrylit. Ensure that the
joints are completely watertight.
- Fit the tillers again and push down gently, that the
O-rings 4.3 are slightly compressed, then tighten
the screws 4.7.
- Connect the two connecting rods 4.8 to both tillers
as shown.
- Set the rudders to the ‚straight ahead’ position and
connect the connecting rods using collet 4.9 and
cap-head screw 4.10. Note that the screws should
face forward.
- Push the guide hoses 4.11 on the screw heads. The
hoses serve as a guide for the allen key for
subsequent maintenance work when the deck has
been fitted permanently.
Stage 5, Installing the RC system, parts 5.1 – 5.17
No.
Description, size in mm Qty. Notes
5.1 Speed controller support 1 Lsr.
5.2 Steering servo 1 N.I.
5.3 Cruciform output lever 1 with 5.2
5.4 Steering pushrod D 1,5 x 40 1 1 z-bend
5.5 Rudder pushrod D 1,5 x 200 1 1 z-bend
5.6 Collet D 3 1
5.7 Grubscrew M3 x 3 1
5.8 Glue-fitting ring 4
5.9 Rubber band 2
5.10 S-hook 2
5.11 Drive battery 1-2 N.I.
5.12 Speed controller 1 N.I.
5.13 Y-lead 0-1 N.I.
5.14 Receiver 1 N.I.
5.15 Receiver battery 0-1 N.I.
5.16 Switch harness 1 N.I.
5.17 Double-sided foam tape 3
- Glue the speed controller support 5.1 to the
intallation cradle, noting that it stands on edge.
- Remove the output disc from the steering servo 5.2.
Set the servo to neutral from the transmitter.
- Cut down the cruciform output arm 5.3 as shown, fit
it on the steering servo and secure it with the
retaining screw.
- Press the rubber grommets and metal spacer
sleeves into the mounting lugs of the steering servo
and place the servo in the cradle. Mark and drill the
mounting holes and screw the servo in place.