Kramer Electronics Ltd.
VW-16
– Operating and Controlling VW-16
16
To use the factory default:
1. On the front panel press
MENU
. The menu shows.
2. Select
SYSTEM
>
FACTORY DEFAULT
press
Enter
and set the factory default
parameters based on the information in the following table:
Menu Item
Function
ON
Use the factory default settings.
OFF
Do not use the factory default settings.
If “on” is selected, the device is reset to its factory default settings.
Viewing Device Information
To view the input resolution:
1. On the front panel press
MENU
. The menu shows.
2. Select
INFORMATION
>
INPUT RESOLUTION
press
Enter
.
The input resolution for INPUT 1-4 show.
To view the output resolution:
1. On the front panel press
MENU
. The menu shows.
2. Select
INFORMATION
>
OUTPUT RESOLUTION
press
Enter
.
The output resolution shows.
To view the firmware version:
1. On the front panel press
MENU
. The menu shows.
2. Select
INFORMATION
>
FIRWARE VERSION
press
Enter
.
The output resolution shows.
To view the fan speed version:
1. On the front panel press
MENU
. The menu shows.
2. Select
INFORMATION
>
FAN SPEED
press
Enter
.
The fan speed shows.
Operating via Ethernet
You can connect to the
VW-16
via Ethernet using either of the following methods:
•
Directly to the PC using a crossover cable (see
Connecting Ethernet Port Directly to a
•
Via a network hub, switch, or router, using a straight-through cable (see
Ethernet Port via a Network Hub or Switch
If you want to connect via a router and your IT system is based on IPv6, speak to your IT
department for specific installation instructions.
For info on configuring the Ethernet, see