Korg Pa3XLe, User Manual, Page: 458 / 472

454 Assembling the ST-SV1 BK stand
You can use the Korg SV-SV1 BK stand as a steady support for
your Pa3XLe.
Precautions before assembly
Before you begin to assemble the stand, please keep the follow-
ing in mind:
• To assemble the stand, two people are needed. Failing to do
so may damage the instrument and cause injury.
• When placing the instrument on the stand, be careful not
to pinch your hands.
• Be sure to follow the steps in order, and make sure that the
parts are assembled in the correct orientation and position.
• Do not apply weight to the edge of the instrument before
tightening the screws, otherwise it may fall down.
Assembly instructions
1.
Open the packing carton and take out the contents.
Remove the stand (B) from the package by grabbing it by
the four brackets (a). Lay it on the ground, with the legs on
top (see illustration).
2.
Remove the protective sheet, and keep it in a safe place for
future use.
3.
Slightly lift the stand, and push the spring bolt (b) located
under the tubing.
4. Once the spring bolt has been extended, raise the leg (c),
until you hear a ‘click’. At this point, the spring bolt (b) is
automatically retracted, and the leg is fixed in place. Please
repeat the same procedure for all four legs.
5. Lift the bracket (a), and insert it into the corresponding
hole (e) in the leg (c). Repeat the same procedure for all
four legs.
Warning: Be careful not to pinch your fingers between the
leg and the bracket!
Assembling the ST-SV1 BK stand
Pa3XLe User Manual v100 (English).book Page 454 Thursday, May 29, 2014 5:42 PM