Korg Pa3XLe, User Manual, Page: 456 / 472

452 Installing the Pa3XLe Amplification System (PaAS)
Precautions
The (optional) PaAS – Amplification System can be installed,
adding to the instrument a three-way amplification system, a
pair of integrated speakers and a bass-reflex box.
Precautions
• Installation of the Amplification System is done at the user’s
own risk. Korg will assume no responsibility for any damage or
injury resulting from its improper installation or use.
• Be very careful not to make the speaker box fall when installing
it, or it can be damaged.
Installation
1. Remove the protective cap (b) from the connector (c) on
the back of the instrument (a), by gently pulling it and
making it turn down.
2.
Now locate the front (d1) and the rear (d2) side of the
speaker box, to be sure you will place it in the right way.
3.
Lift the speaker box (d) by making the back side (d2) look
toward you and the front side (d1) toward the Pa3XLe.
Align its extruding guide (e) to the matching slot (f) on the
back of the instrument (a). Slightly tilt the speaker box (d)
forward, to prevent the fixing pin (k,
see below ) to damage
the back of the instrument. To align them correctly, use one
of the two plastic stoppers/delimiters (h) as a reference
point, making one of the flanks or the speaker box’s guide
(e) touch it.
Installing the Pa3XLe Amplification System (PaAS)
b
a
b
a
c
d2
d1
e
f
h
d
a
Pa3XLe User Manual v100 (English).book Page 452 Thursday, May 29, 2014 5:42 PM