Korg opsix, Owner'S Manual, Page: 86 / 105

86
Effect name
Knob
Parameter name
Range
Display Full name Display Full name
DEC
Decimator
B
MIX Dry:Wet Mix 0–100
C
FREQ Sampling Frequency 1000–48000 [Hz]
E
BIT Bit Resolution 4.0–24.0
F
DAMP High Damping 0–100 [%]
Adds a lo-fi digital device-like feel. Use the FREQ parameter to control the sampling
frequency and the BIT parameter to reduce the data bit length, each for a different
kind of lo-fi texture.
GRAIN
Grain Shifter
B
MIX Dry:Wet Mix 0–100
C
TIME Time Frame 0–100 [%]
E
SPEED LFO Speed 1/48–4/1
F
RETRIG Retrigger Off, Mod Whl, Damper, Note On,
Velocity, LFO1, LFO2, LFO3
This cuts out the short waveforms from the input signal and plays them back
repeatedly, for an effect that changes the signal into a mechanical sound. The TIME
parameter sets the length of the waveform to cut, and the SPEED parameter sets how
fast to switch between the waveforms.
LIMIT
Master Limiter
B
THRE Threshold −30.0 – 0.0 [dB]
C
CEIL Out Ceiling −30.0 – 0.0 [dB]
E
REL Release 0.65–1000.00 [msec]
This effect averages out the changes in volume of the input signal. Only signals that
exceed the specified level will be compressed, which brings down unnecessary peaks
in sound. The THRE parameter sets the level at which the compression is applied, and
the CEIL parameter sets the output level.
COMP
Compressor B MIX Dry:Wet Mix 0–100
C SENS Sensitivity 0–100
E ATTACK Attack 0–100
F LEVEL Output Level −Inf, −84.9–0.0 [dB]
This compressor models the extremely popular clean-sounding pedal effects.
DLY/DLY e
Delay/Delay (BPM)
B
LEVEL Delay Level 0–100
C
FDBK Feedback 0–100 [%]
E
DLY L Delay Time L 0 [msec] – 2.73 [sec] / 1/48–4/1
F
DLY R Delay Time R 0 [msec] – 2.73 [sec] / 1/48–4/1
This is a simple stereo delay with feedback.
PDLY/PDL e
Autopan Dly/Autopan
Dly(BPM) B LEVEL Delay Level 0–100
C DEPTH Auto Pan Depth 0–100 [%]
E DLY Delay Time 0 [msec] – 1.36 [sec] / 1/48–4/1
F SPEED Speed 0.020–20.000 [Hz] / 1/48–4/1
A stereo delay that pans the delay sound left and right using an LFO.
TDLY/TDL e
Tape Echo/Tape Echo
(BPM) B LEVEL Delay Level 0–100
C FDBK Feedback 0–100 [%]
E DLY Delay Time 0 [msec] – 2.7000 [sec] / 1/48–4/1
F DAMP Damping −100.0 – +100.0 [%]
This effect models tape saturation and tape echo. The DAMP parameter sets the
amount of high-end and low-end attenuation.