62
Motion Sequence Functions (When “TARGET” is MTN LANE 1...6)
CLEAR:
Deletes the motion sequence for the selected lane. This turns DEST off, deletes the
routing, resets the VALUE for each step and changes the CURVE to “LIN”.
DUP:
Copies the selected step. Use START and END to select the copy source range, and DEST
to select the start of the copy destination. The REPEAT parameter allows you to sequentially
copy/paste the selected motion multiple times.
COPY VALUE:
Copies the VALUE only for the selected step. Use START and END to select the
copy source range, and DEST to select the start of the copy destination. The REPEAT parameter
allows you to sequentially copy/paste the selected motion multiple times.
COPY CURVE:
Copies the CURVE only for the selected step. Use START and END to select
the copy source range, and DEST to select the start of the copy destination. The REPEAT
parameter allows you to sequentially copy/paste the selected motion multiple times.
SET VALUE:
This sets the values for the range that you selected using START and END to the
same VALUE.
SET CURVE:
This sets the curve for the range that you selected using START and END to the
same CURVE.
ASSIGN RAMP:
This changes the VALUE for the range that you selected using START and
END and creates a waveform. Use “SCALE” to set the gain and polarity, and “OFFSET” to set the
up/down offset.
ASSIGN SAW:
This changes the VALUE for the range that you selected using START and END
and creates a waveform. Use “SCALE” to set the gain and polarity, and “OFFSET” to set the up/
down offset.
ASSIGN TRI:
This changes the VALUE for the range that you selected using START and END
and creates a waveform. Use “SCALE” to set the gain and polarity, and “OFFSET” to set the up/
down offset.
ASSIGN TRI+:
This changes the VALUE for the range that you selected using START and END
and creates a waveform. Use “SCALE” to set the gain and polarity, and “OFFSET” to set the up/
down offset.
ASSIGN SINE:
This changes the VALUE for the range that you selected using START and END
and creates a waveform. Use “SCALE” to set the gain and polarity, and “OFFSET” to set the up/
down offset.
ASSIGN SQR:
This changes the VALUE for the range that you selected using START and END
and creates a waveform. Use “SCALE” to set the gain and polarity, and “OFFSET” to set the up/
down offset.
ASSIGN RAND:
This changes the VALUE for the range that you selected using START and
END and creates a waveform. Use “SCALE” to set the gain and polarity, and “OFFSET” to set the
up/down offset.
Summary of Contents for opsix
Page 1: ...E 1 Owner s Manual...
Page 105: ...2020 Published XX 2020...