Korg opsix, Owner'S Manual, Page: 29 / 105

29
4. Using the step sequencer
The opsix has a polyphonic sequencer that features up to 16 steps. Sequence data for the step
sequencer can be saved in each program. In addition to note data, you can also record and play back
motion sequences (these are changes made to the sound using the knobs or sliders on the opsix).
How the sequencer works
MIDI signal flow
When a MIDI message is received, it will be processed in the sequencer and sent to the next block.
For example, MIDI notes received during recording are recorded in the sequencer and passed on to
the DSP (sound generator) to output the sound.
As shown in the diagram, MIDI messages are sent only to the modules ahead. For this reason, the
arpeggiator can be used to play the sequencer, but the arpeggiator notes cannot be recorded with the
sequencer.
Key trigger mode is a feature that resets the sequence each time a key is pressed, and transpose the
notes according what key was pressed.
Notes can be recorded in real time or in step mode. Motions can be recorded in real time, and the
values in each motion step can be edited on the SEQUENCER page.
Note sequencer
The note sequencer features 16 steps. Up to six notes (from C-1 to G9) can be recorded in a single
step, and the parameters of each note can be adjusted. When the “SWING” effect is off, all step
lengths will be the same. Use “RESO” to set the length of a step respective to the tempo.
Motion sequencer
The motion sequencer features 16 steps. The motions for up to six parameters can be recorded and
played back. This motion data is recorded in “lanes.” The opsix motion sequencer basically works like
the automation feature found on DAWs. The length of each step is also the same on the motion
sequencer. To assign a parameter to a lane, use a knob or slider in real time to record changes to the
parameter, or select “DEST.”