47
Flow Control : off
Default Port VLAN ID: 1
Acceptable Frame Type : All
Auto Negotiation : Enable
Loopback Mode : None
STP Status: Forwarding
Default CoS Value for untagged packets is 0.
Medium mode is Copper.
Note: Administrative Status -> Port state of the port. Operating
status -> Current status of the port. Duplex -> Duplex mode of
the port. Speed -> Speed mode of the port. Flow control ->
Flow Control status of the port.
Rate Control
Rate Control –
Ingress or Egress
Switch(config-if)# rate-limit
egress Outgoing packets
ingress Incoming packets
Note: To enable rate control, you should select the Ingress
or Egress rule first; then assign the packet type and
bandwidth.
Rate Control -
Bandwidth
Switch(config-if)# rate-limit ingress bandwidth
<0-1000000> Limit in kilobits per second (FE: 0-100000,
GE: 0-1000000, 0 is no limit)
Switch(config-if)# rate-limit ingress bandwidth 800
Set the ingress rate limit 800Kbps for Port 1.
Storm Control
Strom Control – Rate
Configuration (Packet
Type)
Switch(config-if)# storm-control
broadcast Broadcast packets
dlf Destination Lookup Failure
multicast Multicast packets
SWITCH(config)# storm-control broadcast ?
<1~1000000> Rate limit value 1~1000000 Kbits/sec
SWITCH(config)# storm-control broadcast 1000
Enables rate limit for Broadcast packets for Port 1
SWITCH(config)# storm-control multicast 1000
Enables rate limit for Multicast packets for Port 1
SWITCH(config)# storm-control dlf 1000
Enables rate limit for Destination Lookup Failue packets for
Port1.
Display
–
Rate
Configuration and
port status
SWITCH# show storm-control
Storm-control rate limit:
Storm-control for Port 1
Broadcast packets: Enabled Rate: 992 (Kbps)
Destination Lookup Failure packets: Enabled Rate: 992
(Kbps)
Multicast packets: Enabled Rate: 992
(Kbps)
Storm-control for Port 2
Broadcast packets: Disabled
Destination Lookup Failure packets: Disabled
Multicast packets: Disabled
Summary of Contents for JetNet 6910G-M12 Series
Page 5: ...1 5 4 About Korenix 141...
