Kontron KISS4U, User Manual, Page: 42 / 60

page 42 KISS4U User’s Guide
Instructions for Installation in a 19” Cabinet
Important: Install expansion cards before installing the KISS-system into an
industrial cabinet or a control panel. Refer to the “Accessing Internal
Components” section.
Before closing the industrial cabinet, connect the peripheral devices to the
system interfaces. Refer to the “Interfaces on the Rear Side” subsection for a
detailed description of the interfaces.
WARNING
If you mount the KISS-system into an industrial cabinet, it is
advisable to have two people do the mounting because the system
weighs approx. 20 kg (approx. 44 lbs.).
CAUTION
The KISS-Platform should only be installed by trained and qualified
personnel.
The KISS-Platform should be installed into a 19”-industrial cabinet
with mounting rails. Check the load capacity of the mounting rails
[the unit may weigh up to 20 kg (approx. 44 lbs.)].
Ensure there is sufficient air circulation around the device when
installing the KISS-Platform. The openings for air intake and exhaust
on the device must not be obstructed. Leave at least 5 cm (approx.
2”) of free space in front of and behind the unit to prevent the device
from possibly overheating!
CAUTION
The 19" industrial cabinet must stand firmly in place. You can
improve its stability by placing components into it from the bottom
up. Heavy components should be placed down below. If further
stabilization is necessary, then bolt the 19" industrial cabinet to the
floor or anchor it on the wall.
The voltage feeds must not be overloaded. Adjust the cabling and
the external overcharge protection to correspond with the electrical
data indicated on the type label located on right side of the unit.