Kontron KISS4U, User Manual, Page: 30 / 60

page 30 KISS4U User’s Guide
Interfaces on the Rear Side
Note: The number of KISS-Platform interfaces will vary depending on the
configuration.
External Interfaces of the integrated Motherboard
Note: The external interfaces will vary depending on the integrated
motherboard. Refer to the information and technical data in the supplied user
manual of the motherboard.
External Interfaces of the integrated SBC-board
Note: The external interfaces will vary depending on the integrated SBC-board.
Refer to the information and technical data in the supplied user manual of the
SBC-board.
Additional Interfaces in Configurations with an SBC-board
Serial Interfaces (COM1, COM2)
These connections are available as 9-pin D-SUB plugs and allow you to connect serial
peripherals. These additional interfaces are configured as RS232. Refer to the
information and technical data in the supplied user manual of the SBC-board.
Parallel Interface Connector LPT1
This connector is available as a 25-pin D-SUB socket. The parallel interface LPT1
supports different modes: SPP, EPP and ECP. It is used for the connection of an
external printer and can also be used for other external devices which can be connected
via a parallel port. Nonetheless, depending on the device, the manufacturer’s
instructions must be observed and the necessary software driver installed.
USB Interfaces
KISS is equipped with two USB interfaces at the front side. These connectors allow you
to connect different USB-compatible devices to the KISS-Platform.