Page 1 - 6
ID 34424, Rev. 3.0
Introduction
CP307
CUSTOMER SPECIFIC
P R E L I M I N A R Y
1.3
Optional Modules
1.3.1
CP307-HDD Module
The CP307-HDD module for the 8 HP CP307 version provides legacy PC I/O ports. It includes
one digital DVI port, two USB 2.0 ports, one COM port, a PS/2 keyboard and mouse port, one
IDE connector, and one CompactFlash socket. A SATA hard disk interface is also available for
mounting a 2.5” hard disk drive.
Refer to Appendix A for further information on the CP307-HDD module.
1.4
System Relevant Information
The following system relevant information is general in nature but should still be considered
when developing applications using the CP307.
1.5
Board Diagrams
The following diagrams provide additional information concerning board functionality and
component layout.
Table 1-1: System Relevant Information
SUBJECT
INFORMATION
System Configuration
The CP307 system controller board can support up to 7 peripheral boards with 32-
bit and 33 MHz.
Master/Slave Functionality
The CP307 can operate only as a master board.
Board Location in the System
The CP307 board must be installed in a system slot of a CompactPCI backplane.
Hot Swap Compatibility
The CP307 supports the addition or removal of other boards whilst in a powered-
up state. Individual clocks for each slot and ENUM signal handling are in compli-
ance with the PICMG 2.1 Hot Swap specification.
Hardware Requirements
The CP307 can be installed in any CompactPCI 3U rack.
Operating Systems
There are various operating systems available for the CP307. For detailed infor-
mation, please contact Kontron.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com