COMe-bKL6 – User Guide Rev.1.2
www.kontron.com
// 72
Sub-Screen
Function
Second level Sub-Screen / Description
H/W Monitor>
(continued)
CPU Fan –
Fan Trip Point>
Displays temperature at which the fan accelerates. (Range: 20°C – 80°)
[50]
CPU Fan –
Trip Point
Speed>
Displays Fan speed at trip point in %. Minimum value is 30 %.
Fan always runs at 100 % at TJmax (-10°C).
[50]
CPU Fan – Ref.
Temperature>
Determines temperature source used for automatic fan control
[PCH Temperature, Module Temperature, CPU Temperature]
External Fan-
Fan Control>
Sets Fan Control mode for external fan
Disable - stops the fan
Manual – manually set the fan
Auto - hardware monitor controls cooling, similar to ACPI based ‘Active
Cooling’, without producing a software load to the system.
[Disable, Manual, Auto]
External Fan–
Fan Pulse>
Displays number of pulse fan produces during 1 revolution (Range: 1-4)
[2]
External Fan-
Fan Trip point>
Displays temperature at which fan accelerates. (Range: 20°C to 80°C)
[50]
External Fan-
Trip Point
Speed>
Displays Fan speed at trip point in %. Minimum value is 30%
Fan always runs at 100% at TJmax (-10°C)
[50]
External Fan
Reference
Temperature>
Determines temperature source used for automatic fan control
[PCH Temperature, Module Temperature, CPU Temperature]
Additional information External Fan
An external fan can be connected to baseboard. The external fan’s control lines are routed via
the COMe connector.
5.0V Standby>
Read only field
Displays standby voltage
Batt Volt. at
COMe Pin>
Read only field
Displays battery voltage at COMe pin
Widerange Vcc>
Read only field
Displays wide range VCC
Serial Port
Console
Redirection>
COM0
Console
Redirection>
Console redirection via COMe module’s COM1.
If redirection is enabled then the port settings such as Terminal type, Bits
per second, Data bits, Parity etc. can be adjusted here.
Note: on-module COM ports do not support flow control.
[Enabled, Disabled]
COM1
Console
Redirection>
Console redirection via COMe module’s COM2.
If redirection is enabled, then the port settings such as Terminal type, Bits
per second, Data bits, Parity etc. can be adjusted here.
Note: On-module COM ports do not support flow control.
[Enabled, Disabled]
