KONRAD 600B SERIES INSTALLATION GUIDE
JANUARY 2019 - V4.0
PAGE 73
Step 15: Installation Review (continued)
Installation Checklist-Outside of Vessel
Please initial when completed:
Verify Serial #’s on drives for proper ratio and rotation.
X-Dimension: Confirm proper height. Verify from application drawing.
Confirm propeller specs for correct diameter and pitch.
Verify that alignment was done correctly for close couple or remote mount per your install type.
Confirm proper oil level in sterndrives.
External Steering: Confirm torque specs on fasteners. Steering rams, tie bars, etc…
Twin applications: Confirm centerline distance of drives on transom and take measurement from center
to center on propshafts to make sure drives are in-line.
Inspect all hoses and fittings on trim and steering lines for any leaks at connection points and also
proper routing of hoses.
Confirm proper orientation of bellows and check for secure connection on drive and gimbal assembly.
Tighten hose clamps.
Check for continuity from prop shaft of sterndrive all the way to the gimbal assembly, including the
gimbal housing, trim cylinders, and steering cylinders.
Check stern drive for side to side play. The movement should be minimal to none.
Check for proper continuity on drive from prop shaft to transom using a volt meter.
Verify correct adjustment of electrical trim senders.
Inspect bottom of hull for any protrusions impeding clean water flow to propellers. Ex. Transducers,
water pickups, anodes, etc…(See drawing in Installation Guidelines section)
Inspect mounting area of transom for flatness and correct 13
o
degree mounting angle.
Prepare vessel for sea trail, fill out Application Trial Data Forms on following pages. Send in Konrad Warranty
Registration and sea trial forms to Konrad Marine.
