KONRAD 600B SERIES INSTALLATION GUIDE
JANUARY 2019 - V4.0
PAGE 16
3.6
Apply marine grease onto center pin
and
reinstall the center pivot pin (13-561) into the lower
gimbal ring and into the intermediate section the
drive.
Note:
Use the slot on the bottom of the pin to align
the hole for the retaining bolt at the bottom of the
intermediate housing.
3.7
Put red
Loctite
on the H.H.C.S. (13-560)
and install into the intermediate section (as shown
in picture to the right). Tighten into the center pivot
pin at 50 lb.ft. (67.8 Nm).
3.8
Reinstall the bottom cover (13-320), lock
washers (13-670), and the H.H.C.S. (13-310). Ap-
ply blue
Loctite
and tighten the H.H.C.S. to 35 lb.ft
(47.5 Nm).
3.9
Remove the screw from the top starboard
side of the intermediate and attach the continuity
cable from the transom assembly.
Step 3: Drive Leg Installation (continued)
3.10 Reinstall the top cover plate with rudder
indicator sensor (if equipped) facing forward align-
ing the sensor and wiring with the slot on the top
portion of the pivot pin.
3.11 Apply blue
Loctite
to the H.H.C.S (12-378)
and reinstall into the washers (13-670), and top
plate, then tighten into the gimbal ring.
NOTE: There is a small indicator on the shaft of
the sensor indicating the side that must align with
the wiring, and the slot in the shaft. (See arrow in
picture)
