KONRAD 600B SERIES INSTALLATION GUIDE
JANUARY 2019 - V4.0
PAGE 60
Step 11: Drive Shaft Alignment Procedures
A) U-Joint Extension Shaft
Note:
We recommend using a dial indicator to check
the transmission flange facial and circumference mea
-
surements to ensure all measurements are within .010
in. (.25mm) when rotating the flange.
1. We suggest using tool (TO-186) to bolt onto the
flange faces of the transmission and the gimbal
housing to make measuring the distances easier.
If aligning without Konrad tool (TO-186)
then skip ahead to the NOTES and alignment
specifications chart.
2. Place one of the alignment sticks onto the gimbal
flange with the beveled edge facing away from
the gimbal flange and fasten using two 13-625
H.H.C.S.
3. Take the remaining alignment stick and fasten it
to the transmission output flange using two
13-716 bolts and two 11-247 nuts
.
