KONRAD 600B SERIES INSTALLATION GUIDE
JANUARY 2019 - V4.0
PAGE 17
3.12 Install the steering rams onto the drive
by placing the two (2) bushings (13-319) on the
steering ram eyelet. Place the steering ram between
the steering tabs on the drive. Clevis pin (13-341),
slides through the top steering tab and downward
through the steering rod and out the bottom tab.
Install flat washer (12-352), and secure with cotter
pin (13-368) by sliding through the hole at the bot-
tom of clevis pin and bending the legs of the cotter
pin back around the outside of the clevis pin.
Repeat this process for both port and starboard
sides.
3.13 Remove lifting ring from drive and reinstall
gasket (10-285) and plug (10-010) into top cap (13-
421).
3.14 Remove cap (13-012) from fitting (11-702).
Place
blue
Loctite
on oil vent hose fitting (11-702),
and install oil supply hose (31-130) from the gim-
bal housing and tighten.
3.15 Install the cover onto the upper housing.
Place blue
Loctite
onto the S.H.C.S. before placing
them through the flat washers and hand tighten.
Install two (2) M6 X 18mm S.H.C.S (13-696) into
the forward upper side of the cover. Install two (2)
M6 X 18mm S.H.C.S (13-696) into each forward
bottom side hole in the cover.
3.16 Install two (2) M6 X 18mm S.H.C.S. (13-
696) with
blue
Loctite
and washers (12-335) on the
aft side of the cover and tighten.
3.17 Install splash deflector (13-403), using the
four (4) H.H.C.S. and washers supplied with the de-
flector plate into the lower gimbal housing. Apply
red
Loctite
to the bolts and tighten to 35 lb.ft. (47.5
Nm)
See photo to right.
Step 3: Drive Leg Installation (continued)
