KONRAD 600B SERIES INSTALLATION GUIDE
JANUARY 2019 - V4.0
PAGE 24
Step 7: Trim Control Wiring Installation (continued)
7.5
Reinstall the top portion of the trim pump as-
sembly bracket that was previously removed.
7.6
Unwrap the twist ties from the wires for the
trim and rudder indicator (if equipped) sensor(s).
Route the wires across the transom securing every
6 inches Keep track of which wire harness goes to
which sensor.
The port side harness is for the rudder indicator
The starboard side harness is for the trim.
7.7
Feed the wires through grommet in the top
opening of the trim pump assembly bracket and con-
nect them to the appropriate terminals of the 6 position
horizontal terminal strip.
NOTE: The black wires are routed to terminal 2.
The yellow wire for the trim is routed to terminal 4.
The yellow wire for the rudder is routed to terminal 3.
The red wires are routed to terminal 5.
NOTE: Numbering for the terminals starts on the left
side with number 1 and goes to the right.
NOTE: Coat the terminals with corrosion protectant.
7.8
Route the low oil level sensor wires from the
oil reservoir to the trim pump and attach to the posi-
tions 1&2 on the 4 position vertical terminal.
NOTE: Numbering for the terminals starts on the top
side with number 1 and goes downward.
NOTE: Coat the terminals with corrosion protectant.
7.9
Reattach the trim pump assembly cover.
