Konica Minolta CM-23d, Instruction Manual

Page: 65 / 151

62 61
Measur
ement
2
„ Set group
In order to facilitate classification of targets into groups, up to five groups to which data should be categorized can
be configured. After the targets have been registered to a group, the filtering function can be used to display only
the selected target data. This section describes the registration of a group.
Memo
• If a new target is measured, the measurement will be assigned to the appropriate group according to the default
settings.
• Display the group of the target to be set on the <Target> screen in advance.
Operating Procedure Start the procedure from the <Target menu> - <Data management> screen.
1
Use [
▲
] or [
▼
] to move the cursor to “Set group”,
and then press the [Confirmation] key.
The <Edit group> screen is displayed.
2
Use [
▲
] or [
▼
] to move to the cursor to the group
number column to which the current target should
be applied, and then press the [Confirmation] key.
3
Use [
▲
] or [
▼
] to move the cursor to select the
group value to which the target should be applied,
and then press the [Confirmation] key.
The selection is confirmed and the screen returns to the
<Target> screen .
Memo
Group names configured in advance through
<Default data
setup> in accordance with group numbers are displayed.
4
Select “OK”. Selecting “Cancel” will cause the
display to return to the <Data management> screen
without changing the settings.
Notes
If [ESC] is pressed without pressing the [Confirmation]
key, the settings will not be changed and the screen will
return to the <Data management> screen.