Kongsberg EM 710, Installation Manual

Page: 42 / 155

Kongsberg EM 710
4.6.1 Logistics and references
Safety - Refer to the general safety procedures. Note that the
individual units are heavy !
Personnel - Trained mechanical workers and installation
engineers from Kongsberg Maritime AS.
Ship location - Dry dock
Special tools - None
References - Refer to the following drawings in the Drawing
File:
Note
Note that engineers from Kongsberg Maritime must be present to
install the transducer modules.
4.6.2 Procedure
How to install the RX and TX transducer array
modules
Observe normal safety precautions for dockyard work.
Caution
The transducer modules and the cables must be handled
with care! The modules are heavy!
DO NOT LIFT THE MODULES BY THE CABLE!
Tx transducer modules
Note
When installing Tx transducer modules, fill in the “Location of
Tx modules“ table!
1 If using mounting frames, hold the first transducer module
up in the frame, else mount the module directly to the hull.
2 Pull out the transducer cable, and guide them out through the
side of the mounting frame (if applicable).
3 Either (when using mounting frames) :
• Place the transducer modules into the frames and fasten
them by the stay rods and clamping lists. The clamping
lists are fastened to the mounting frames by M10 bolts
with self lock treads. Use a maximum toque of 42 Nm
and lubricate with Loctite 242.
Or (when mounting directly in the hull)
40
164851/C