Kongsberg EM 710, Installation Manual

Page: 150 / 155

Kongsberg EM 710
10.2.15 RX/TX transducer cables
These are the cables from the EM 710 Transceiver Unit to
the RX/TX transducer arrays. Each cable is terminated at
the cabinet’s rear through a 78–pin D-sub connector. At the
transducer end, the cables are moulded to their respective arrays.
The cables are supplied by manufacturer.
W815
Rev.A
RX/TX transducer cable termination
Looking into a male 78-pin D-sub connector
This end is terminated
in the RX or TX sub-rack
This end is molded to
the transducer array
Reg. no. and serial no.
Pin 1
Pin 78
The following table displays the pin assignment in the transducer
cable from the RX RIO board in the Transceiver Unit to the RX
transducer
Table 9 RX transducer cable pin assignment
Module
no.
Element
no.
Pin no. Wire colour code
1 1 1 21 White Brown
1 2 40 60
Green
Yellow
1 3 2 22 Grey Pink
1 4 41 61 Blue Red
1 5 3 23 Black Violet
1 6 42 62 Grey/pink Red/blue
1
7
4 24 White/green Brown/green
1 8 43 63 White/yellow Yellow/brown
1 9 5 25
White/grey Grey/brown
1 10 44 64 White/pink Pink/brown
1 11 6 26 White/blue Brown/blue
1 12 45 65 White/red Brown/red
148
164851/C