Kongsberg EM 122, Installation Manual

Page: 140 / 154

EM 122
Internal control signals
This cable is used to transmit synchronization signals and TX enable signals. It is
terminated in a standard 15–pin D-sub connector.
W243
Rev . A
EM Control signals
1
2
3
4
10
6
12
9
15
8
14
7
13
5
11
TX Enable ()
TX Enable (TXEN_TX-)
Synchronization ()
Request to Send (R TS)
Synchronization (SYNC_TX-)
Ground (GND)
Clock ()
Trigger ground (TRIG GND)
Clock (2MHZ_TX-)
Trigger out (TRIG OUT)
Reset (R)
Not connected (NC)
Reset (RESET_TX-)
Not connected (NC)
Clear to Send (CTS)
Local 15-pin
‘ D ’ connector
Remote unit to be
connected as described in
applicable documentation
Looking into a female
15-pin D-pin connec tor
9 15
8 1
• Conductors: 9 x 2 x 0.5 mm²
• Screen: Screened twisted pairs and overall braided
• Voltage: 60 V
• Maximum diameter: Limited by the plugs
138
317669/B