Kongsberg EM 122, Installation Manual

Page: 35 / 154

Transducer arrays
For the mounting of TX array in the frames, there are no orientation limits. However, for
the RX array there are some limitations.
RX array with casing – 2 degree on page 117
RX transducer modules
Note
When installing RX transducer modules, fill in the “Location of RX modules“ table!
on page
1
Put the first transducer module into the frame.
• This module is mounted at either end of the array.
Note
Observe that you install the module so that it faces the correct way.
2 Pull out the transducer cable, and guide it out through the cable penetration in the
baffle plate on the bottom side of the mounting frame.
3
Secure the transducer module in place with the brackets, one on each side.
• Use torque approximately 64 Nm.
4 Mount the next transducer module next to the previous.
5
Repeat until all modules have been installed.
6 Check that the transducer cables pass through the casing in such a way that they
are not exposed to wear and tear. Secure as required.
7
Check that all bolts are properly fastened.
TX transducer modules
Note
When installing TX transducer modules, fill in the “Location of TX modules“
on page
317669/B
33