181
⑥
A dialog box shows the distances
from intersection to PT1 and PT 2.
※
1)
⑦
Click “OK”, the intersection is
set out.
※
1) Click“
” to quit batter board program.
※
The setout of this intersection point is identical to Point Setout, which is discussed
in paragraph 13.1.3, except for two differences.
1)
Automatically the intersection point is chosen for setting out.
2)
CUT is not shown at the screen.
NOTE
：
1)
If the intersection point is not on the batterboard, the message “Point Not on
Batterboard!” is shown on the screen.
2)
In case a batterboard is used twice and its position hasn‟t changed, it is not
necessary to re-measure the sides of the batterboard. Use the same number for the
sides of the batterboard.
3)
The error message “Invalid value
！
”is shown if the batterboard and the line
connecting the two setout points are parallel.
4)
The coordinates of the calculated intersection point are recorded in the coordinate
file. The number of this intersection point is, compared to the highest existing
number, incremented by one.
13.5.2 Method 2: Batterboards using one side
Click [S.O.] in case you want to measure only one side of the batterboards.
