Kohler KDI 2504 M-MP, Owner'S Manual

Page: 28 / 80

6
28 _ 00
A
A
C
D
E
Fig. 6.2
Fig. 6.1
Fig. 6.3
MIN
MAX
B
B
ED0053031100
INFORMATION ABOUT REPLACEMENTS
EN
6.1 Engine oil replacement
Important
• Place engine on horizontal surface to ensure accurate
measurement of oil level.
NOTE: Perform this operation with warm engine, to get a
better fluidity of the oil and get a full discharge of oil
and impurities contained in it.
1 - Loosen the oil filler cap A .
2 - Remove the oil dipstick B (Fig. 6.3) .
3 - Remove oil drain plug D from pump E .
4 - Start pump E and drain the oil in the engine.
5 - Drain oil in an appropriate container.
(For the exhausted oil disposal, refer to
Par. 6.9 DISPOSAL and SCRAPPING ).
6 - Tighten the drain oil plug D (tightening torque at 10 Nm ).
7 -
Perform the operation described in
Par. 6.2
.
8 - Add the type oil recommended ( Tab. 21 and Tab. 2.2 ) .
9 - If the plug A is not accessible, use the oil filler cap C .
10 - Fit and remove the oil dipstick B to check the level.
Pour in fluid until reaching the MAX level mark.
11 - Upon completion, reinstall the oil dipstick B completely.
12 - Tighten the cap A or C .
Important
• Do not exceed the
MAX
level on the dipstick.
• Do not use the engine with the oil level below the MIN .
Danger
Disconnect the negative wire (-) from the battery to avoid accidental engine starting.
Important
• Before proceeding with operation, read Par. 3.2.2