Kohler K-3363, Manual

Page: 32 / 220

© 2012 Bradley
P.O. Box 309, Menomonee Falls, WI 53052-0309
Phone: 800.BRADLEY(800.272.3539) Fax: 262.253.4161
bradleycorp.com
Page 1 of 3
This information is subject to change without notice.
11/27/2012
Plumbing Fixtures
Document No. 2510
• cUPC Certified
• Serves One to Three Users at a Time
• Unique, Repairable, Solid Surface Material
• Highly Vandal Resistant
• Saves Water, Energy and Space
• ADA Compliant
Specifications
Size and Capacity
Accommodates 1-3 users at a time, using less water, energy and space than three lavs
equipped with conventional faucets. The pre-assembled sprayhead module is equipped
with three independent streamformers, each controlled by a separate push button or
infrared sensor.
Flow Control/Rate
Operating water pressure range is 20–80 psi. Flow regulators keep flow rate constant at all
pressures. A flow restrictor keeps the flow rate at constant a .5 GPM under any pressure.
Construction
Bowl and Pedestal
Constructed of Terreon
®
, a densified solid surface material composed of polyester resin,
or Terreon
®
RE, a densified solid surface material composed of a bio-based resin and
preconsumer recycled granules. Terreon and TerreonRE are resistant to chemicals, stains,
burns and impact. Surface damage can be easily repaired with everyday cleansers or fine
grit abrasives. Terreon and TerreonRE are NAHB certified to meet ANSI Z124.3, Z124.6
and ANSI/ICPA SS-1-2001. Terreon and TerreonRE are GREENGUARD
®
certified as low-
emitting materials. Pedestal frame and access panels are constructed of heavy gauge type
304 stainless steel.
Vandal Resistance
The molded sprayhead is an integral element of the bowl module. All streamformers,
escutcheons and push buttons/infrared sensors are secured to the unit from inside the
sprayhead module. All valves, water supplies and waste connections are concealed inside
the pedestal. The front access panel is removable only with a hex key. The Terreon and
TerreonRE bowls are resistant to stains, burns and impact. Surface damage is easily
repaired and repair work is virtually undetectable.
Standard Equipment
Valves and Fittings
In addition to the bowl and pedestal, the following valves and fittings are standard:
Navigator
®
thermostatic mixing valve, stop valves, drain spud, flexible stainless steel
supply hoses. Stop valves mount onto 1/2" nominal copper tubing.
Activation Controls
Air Valve Hand Control
Each push button pneumatically actuates a non-hold-open, air metering, single-
temperature valve with field adjustable timing from 0–45 seconds. Factory preset at 10
seconds. Each push button activates one valve which, in turn, activates one station. Push
button requires less than five pounds of pressure.
Infrared Control
Each of the stream formers is controlled by a separate solenoid valve. Hands placed within
the bowl are detected by an infrared sensor which activates a flow of tempered water from
one station. Shut-off is automatic after hands are removed from the detection area. The
infrared sensor uses a conical-shaped transmitting beam, having a detection area adapted
to, but not exceeding, the bowl perimeter. The adaptive infrared sensor automatically
adapts to the bowl after power is turned on. The infrared sensor is not affected by varying
color tones or darkness. Direct sunlight or bright washroom lights will not activate the
system. Infrared models also include solenoid valves and a low-voltage transformer as
standard equipment:
• Solenoid – 24V, 50/60 Hz, 5/16" tube fitting. Few moving parts, and resistant to most
chemicals, minerals, and impurities often present in municipal water supplies.
• Low-Voltage Transformer – Class II UL/CSA listed, 110/24 VAC plug-in transformer.
Plugs into a standard GFCI protected electrical outlet. Location of transformer per
local electrical code.
Battery Infrared Control
Each battery-powered sensor uses a zone-focused infrared transmitting beam, creating a
large detection area not exceeding the bowl perimeter. The sensor is not affected by varying
skin tones or darkness. When hands enter the detection area, the sensor starts water flow
by opening the solenoid valve electronically. When hands leave the detection area, the
sensor stops the flow of water by closing the valve. The 6-volt DC electronically activated
solenoid valve has few moving parts, providing reliable operation that is unaffected by most
chemicals and minerals often present in municipal water supplies. Each station is powered
by a single lithium battery. Battery type is Duracell
®
DL 223A or equivalent (included).
Battery type is Duracell
®
DL 223A 6 volt lithium or equivalent with a life expectancy of 4-5
years or approximately 200,000 cycles.
TouchTime
®
Hand Control
Each low-voltage button actuates a non-hold-open, slow-closing anti-hammer solenoid
valve that is timed from an electronic potted assembly. Each push button activates one
valve which, in turn, activates one station. TouchTime controls water flow at each station
through the use of solid state, digital circuitry. Timing is electronically controlled at 15
seconds. Push button requires less than five pounds of pressure.
Code Compliance and Certifications
ANSI Standards
Terreon and TerreonRE are certified by NAHB certified to meet ANSI Z124.3, Z124.6 and
ANSI/ICPA SS-1-2001.
cUPC Approval
Terreon Washfountains are Uniform Plumbing Code (UPC), International Plumbing Code
(IPC) and National Plumbing Code of Canada (NPC) approved through the International
Association of Plumbing and Mechanical Officials (IAPMO). Manufactured in compliance with
IGC 156-2009, CSA B45 Series-2002 (R08) & ASME A112.18.1-2005/CSA B125.1-2005.
Barrier-Free
The standard height Tri-Fount is designed to comply with all ADA guidelines on reaches,
clearances and operation.
MF2933
CE
RT
IFIE
D PROD
UC
T
3
0
1
-2
49
-40
00 www.n
ah
br
c.
o
rg
MF2933
Terreon
®
Tri-Fount
™
Washfountains