Kohler K-3363, Manual

Page: 43 / 220

Installation
MF2933/BIR3
Bradley •
215-1371 Rev. M; ECN 12-00-013 11/27/2012 9
LOWER
BRACKET
FRONT
PANEL
SCREW
UPPER
BRACKET
7
Check Operation
A
Check to make sure both stops are fully
open (see page 6) .
B
Turn on the main water supply to the
Tri-Fount and check for leaks .
C
Turn on the electrical power and pass
your hand in front of each sensor until air
is purged from the lines .
This valve is NOT factory preset. Upon installation, the
temperature of this valve must be checked and adjusted
to ensure delivery of a safe water temperature. Water in
excess of 110°F (43°C) may cause scalding.
H
C
D
Loosen Cap Screw about ¼" (4-6 turns)
and lift up cover (do not remove) .
E
Using cover, turn cartridge gently until
desired water temperature is reached . Do
not turn past stops as this may damage
unit . Push cover down and tighten screw .
8 Install Top Cover and Front Panel
A
Carefully place the top cover with
threaded rods on top of washfountain
sprayhead .
B
Inside the pedestal assembly of the
washfountain (use front access), slide
the anchor plate onto the threaded rods
and secure anchor plate against bowl
using the wing nuts provided .
C
To install front panel, slip slot in bottom
of front pedestal panel over the lip on the
lower bracket,
D
Secure panel to upper bracket with
attached screw .