Kohler 11RMY, Service Manual

Page: 74 / 98

TP-5867 11/02 64 Section 8 Disassembly/Reassembly
3. Disconnect the alternator wiring. See Figure 8-3.
a. Disconnect alternator leads 1, 2, 3, and 4. Note
the locations of the lead connections for
reconnection later.
b. Disconnect brush leads FP and FN.
c. Disconnect the speed sensor harness.
4. Disconnect the exhaust system. See Figure 8-4.
a. Remove the four screws securing the top of the
exhaust duct.
b. Remove the engine exhaust muffler.
c. Remove the lower portion of the exhaust duct.
5. Remove the alternator end bracket.
a. Remove two bolts securing the alternator
vibromount mounting plate to the skid. See
Figure 8-5.
b. Raise the alternator end of the generator set
enough to place a thin block of wood beneath
the rear of the engine. See Figure 8-6.
A-358076A-D
4
1
3
2
1. Speed sensor harness connector
2. L0 lead connection point
3. Circuit breaker connections
4. Brush leads FP and FN terminal block connections
Figure 8-3 Controller Top View, Typical
A-358000A-B
1
2
3
1. Exhaust duct
2. Engine exhaust muffler
3. Exhaust duct screws
Figure 8-4 Exhaust Muffler Duct
A-358000A-B
1
1. Alternator vibromount mounting plate hardware
Figure 8-5 Generator Set, Right Side
A-358000A-B
1
1. Engine support block
Figure 8-6 Generator Set, Right Side